熱壓機模板廠家很多是使用不當，熱壓機上用在導熱板和不銹鋼模板中間的緩沖墊。造成使用壽命縮短的合理的使用不只延長緩沖墊的使用壽命，降低生產本錢，還可以提高產品的質量，品相。必需由上到下的順序將緩沖墊安裝在熱壓機導熱板和不銹鋼模板的中間。緩沖墊必需安放平整。先不固定，緩沖墊鋪裝時的注意事項。鋪裝緩沖墊時。防止鋪裝中帶入雜物。然后將升溫到60――80攝氏度，并升壓使壓板成輕微閉合狀態。固定過程中，只需固定長度方向的4個角，寬度方向最好不要固定。壓貼了200――300多張后因受熱后，緩沖墊有輕微收縮，需要停機后重新調整緩沖墊的張緊度。再次壓貼200――300多張后再調整一次。